Designed by a team of extremely experienced engineers and verified by extensive listening tests, each SE2200A Microphone utilises gold sputtered, ultra-light mylar diaphragms in an advanced capsule design. The SE 2200A Microphone is constructed using the finest quality Japanese electronic components and extensively tested to provide you with years of trouble-free operation. Every SE2200A Microphone comes with an individual frequency response plot. The SE2200A tube microphone use traditional, high voltage tube circuitry to ensure thetrue vintage tube sound. This is in contrast to many cost saving tube designs where the tube is run at a very low operating voltage so as to introduce deliberate distortion which their designers hope to pass off as warmth. Whereas most vintage mic tubes are hard to find and extremely expensive, The SE2200A Microphone uses commonly available high performance tubes that are specially selected and matched for low noise operation.
There are two basic microphone directional patterns, omni-directional, which picks up sound equally from all directions, and figure-of-eight, which picks up from both the front and rear of the microphone but not from the sides. Combining these two basic patterns creates a cardioid or directional response, which simply means the SE2200A Microphone is most sensitive in one particular direction. By varying the way in which the omni-directional and figure-of-eight patterns are combined, varying widths of cardioid pattern can be created.
Key Product Features:
Transformer-balanced microphone
Supplied with with metal shock mount cradle and aluminum flight case
High SPL capability at 130dB
Specifications:
Frequency Response: 20Hz-20KHz
Sensitivity: 14.1mV/Pa -37 +/- 1.5dB
Polar Pattern: Cardioid
Impedance: < 50 Ohms
Equivalent Noise Level: 17dB(A weighted)
Max SPL for 0.5% THD@1000Hz: 125dB
Power Requirement: Phantom power 48V +/- 4V
Connector: 3-pin XLR
Includes:
SE-2200A Microphone
Supplied with with metal shock mount cradle and aluminum flight case
Includes Suspension Mount
Reflection Filter
No comments:
Post a Comment