Showing posts with label high cop. Show all posts
Showing posts with label high cop. Show all posts

Monday, 9 May 2011

Using river water to heat a river boat?

River water can be utilised to heat a boat and in the past systems using copper coils in the water have been used in conjunction with heat pumps. However, rules and regulations and the lack of available manufactured equipment have made this type of system less attractive.




Pumping river water through a heat pump can give very good results, but heat pump units require water at temperatures above 5 to 8°C (varying depending on type). Whilst delivering very high-efficiencies for much of the time, this system may fail to operate in the middle of winter during lower temperatures- just when you need the most heat, so a back-up heat source is usually advisable.

Oxygen and contaminants in the river water may also be a concern in some circumstances, causing pump failure and possibly a system refrigerant leak. But don't let me put you off; this system can give excellent results if installed correctly.

For those lucky enough to have a spring, this is a much more stable and better heat source. Its an opportunity not to be overlooked, offering excellent efficiencies. Again, acidity and impurities in the water can sometimes make its use prohibitive, but some heat pump units will tolerate ‘corrosive’ water (some Dimplex models etc). A possible alternative is to use an intermediate heat exchanger in such circumstances. However, the added temperature drop and necessary extra pump can reduce the performance considerably.

The water source should ideally be fairly close to the property, and should not require pumping up any significant height or the power for pumping it may detract from the energy savings. Having said that, water could be taken over considerable distances if the pipe diameter is big enough, especially in a downward direction. It is a relatively simple exercise to calculate the pump power required (if any) to get the water to and through the heat pump unit.

Permission should be sought from the relevant authorities as an abstraction licence may be needed.

Produced by John Cantor

Monday, 2 May 2011

Daikin Air Conditioning announces the introduction of the EWAD~CZ air-cooled inverter chiller range

28/02/2011)

Daikin Europe N.V. announces the introduction of the EWAD~CZ air-cooled inverter chiller range with the highest ESEER in the market – up to 6* – making it an extremely cost-effective solution for use in comfort and other applications where a top level chiller in terms of performance and reliability is needed.

Highest partial load efficiency: ESEER up to 6*
The use of inverter driven screw compressors in the EWAD~CZ range allows the units to achieve the highest partial load efficiency scores in their class (ESEER up to 6*), making it ideal for systems with variable load requirements such as comfort applications. The high partial load efficiency of these solutions allows substantially reduced CO2 emissions and decreased annual operating costs, hence much quicker system payback times.
The use of inverter technology also contributes to quieter sound levels and precise chiller water temperatures, as well as lower starting current requirements, optimum power factors (always above 0.95), a reduction of water tanks for the hydraulic system and increased reliability thanks to fewer compressor start-ups and shut downs.

Innovative technology
Inverter control is complemented by a host of other advanced features such as a patented single screw compressor, and ultra efficient fans with a patented blade profile for quiet operation. Moreover, the Microtech III controller allows easy control of parameters, and a wide range of system integration solutions are supported including LonWorks and BACnet.

Wide range of options
The Daikin EWAD~CZ units operate in ambient temperatures from -18°C to +50°C, with leaving water temperatures from -8°C to +15°C. The new range is available in standard, low and reduced sound models and the extensive list of options includes heat recovery and fan speed regulation (which results in an ESEER up to 6*).
The addition of the new range makes the Daikin Europe N.V. screw inverter chiller portfolio the largest in the market. The new EWAD~CZ range fills in the top of the segment with capacities from 635 kW to 1.800 kW, the highest cooling capacity available in this market today.

For more information on Daikin Europe N.V.’s complete line of chiller solutions for industrial and comfort applications, visit www.daikin.eu.

*with optional fan speed regulation

Monday, 11 April 2011

Mitsubishi Electric MSZ-EF25VEB ZEN (2.5kW / 9000Btu) Inverter Heat Pump Wall Air Conditioning

The new Mitsubishi Elecric air conditioning Zen MSZ-EF series is a stylish, wall mounted system. Featuring the new Nano-Platinum filter system, these models also offer industry leading noise levels (as low as 21dBA* 1 ).and have a distinctively styled front panel that not only looks appealing but also helps to make cleaning of the unit easier. The Mitusbishi Electric Zen models come in three colours white, silver and black (colour option) and use high COP inverter technology delivering economical air conditioning and heating with improved COP figures (4.59). Ideal for use in any size room, many units come equipped with a wide-angle airflow system, as well as an automatic swing vane, allowing airflow to be extended to every corner of a room.

Designed to heat or cool small to medium sized applications, the Zen MSZ-EF Series range provides a artistic and modern air conditioning solution. Unlike conventional models with a grilled air intake, wall mounted models feature a smoothly contoured, flat panel finish with a top air intake that not only improves aesthetics, but also helps to reduce noise as the heat exchanger area is fully covered. Alongside this, the wide diameter of the fan produces greater airflow at lower fan speeds and the uneven pitch between each fan blade helps to eliminate unwanted noise.

Key Product Feature's

• High CoP, up to record 4.59
• Advanced technology control
• Infra-red controller
• Slim artistic construction
• Pipe runs up to 20 metres
• Low noise – 21dBA on smaller models
• Fault diagnosis
• Auto re-start after power interruption
• PRE-CHARGED WITH REFRIGERANT for
up to 7 metres pipe length

• Easy cleaned & serviced.
• Full ECA tax allowance.


Buy On-line at: www.orionairsales.com

MSZ-EF25VEB Indoor Unit
Capacity (kW):
Heating (Nominal) (Low - High)3.20 (1.10 - 4.20)
Cooling (Nominal) (Low - High)2.50 (1.20 - 3.40)
Heating (UK) (Low - High)2.65 (0.90 - 3.50)
Cooling (UK) (Low - High)2.50 (1.20 - 3.35)
SHF R410A (Nominal)0.92
COP / EER (Nominal)4.57 / 4.59
Energy Label Heating / CoolingA / A
Width - mm895
Depth - mm195
Height - mm299
Weight - kg11.5
Airflow (m3/min) (Heating /Cooling) - Lo-Mi1-Mi2-Hi-SupHi4-4.6-6.2-8.9-11.9 /4-4.6-6.3-8.3-10.5
Noise (dBA) (Heating /Cooling) - Lo-Mi1-Mi2-Hi-SupHi21-24-29-37-45 /21-23-29-36-42
Pipe Size Gas mm (in)9.52 (3/8)
Pipe Size Liquid mm (in)6.35 (1/4)
Electrical SupplyFed by Outdoor unit
PhaseSingle
Fuse Rating (BS88) - HRC (A)6
Interconnecting Cable No. Cores4
MUZ-EF25VE Outdoor Unit
Width - mm800
Depth - mm285
Height - mm550
Weight - kg30
Noise (dBA) (Heating /Cooling)48 /47
Electrical Supply220-240v, 50Hz
PhaseSingle
Fuse Rating (BS88) - HRC (A)10
SystemPower Input (kW) - Heating (Nominal)0.7
SystemPower Input (kW) - Cooling (Nominal)0.545
SystemPower Input (kW) - Heating (UK)0.637
SystemPower Input (kW) - Cooling (UK)0.436
Starting Current (A)3.5
SystemRunning Current (A) - Heating / Cooling3.5 / 2.9
Mains Cable No. Cores3
Max Pipe Length (m)20
Max Height Difference (m)12
Charge R410A (kg) - 7m0.8

Friday, 18 February 2011

Super Energy Efficiency Heat Pump Hitachi Summit Wall Air Conditioning RAS-25FH6 (2.5 kW / 9000 btu) Inverter

2.0kW / 6600Btu Heat pump Inverter Split Type Wall mounted Air conditioning System.
The New Hitachi Summit range is highly economical and environmentally friendly, using the latest compressor and inverter technology keeping power consumption minimal, but at the same time providing you with powerfull cooling and heating. High COP

Performance Improved
DC Inverter driven compressors and fans. Enhanced inverter performance and system performance are achieved by the addition of a ‘Direct Current’ drive, resulting in up to 10% more efficient than standard 'AC' (Alernating Current) Systems.

The variable speed compressor(inverter) enables the system to rapidly reach the desired room temperature setting. Once the desired room temperature has been achieved the compressor rotation speed is reduced, saving up to 30% in energy usage (when compared to standard fixed speed systems)

Product Key Feature's

* High CoP, up to record 4.31
* Infra-red controller
* Slim construction 205mm
* Pipe runs up to 20 meters
* Low noise 44dBA on low
* Cold draft prevention on heat pump start up
* Fault diagnosis
* Auto re-start after power interruption
* PRE-CHARGED WITH REFRIGERANT for up to 20 metres pipe length
* Cleaner and healthier air with ion generator incorporated in indoor unit.
* Light weight noise absorbing outdoor unit


RAS Wall Mounted RAS-18FH6
Power source 1 ph 240V
Type Inverter rotary
COOLING (nominal) max. kW 2.0 / 6600 BTU
HEATING (nominal) max. kW 2.5 / 8250 BTU
UK Cooling (max) kW 2.5 / 8250 BTU
UK Heating (max) kW 3.2 / BTU 10600
Fuse Rating 16A
E.E.R. n/a
Energy label in heating A
Energy label in cooling A
C.o.P 4.31
ECA - Yes


Indoor Unit

Exterior dimensions (mm) 280 x 780 x 205
Net weight kg 9.5
Air flow rate* (cooling) (m3//min) 7.3/6.7/5.8
Air flow rate* (heating) (m3//min) 8.0/7.0/5.8
Hitachi Summit, Hitachi air conditioning, Hitachi air conditioning RAS range

Outdoor Unit

Exterior dimensions (mm) 548 x 750 x 288
Net weight kg 35
Power Source Rating MCB A 15A
Refrigerant max piping length m 20
Pipe sizes - 1/4" x 3/8"


Hitachi Summit, Hitachi air conditioning, Hitachi air conditioning RAS range

Friday, 4 February 2011

Therma V Air Heat Pump Model: AHUW126A0 + H12SNE (12 kW / 40000 btu)

Therma V Air Heat Pump Model: AHUW126A0 + H12SNE (12 kW / 40000 btu)

Lg Therma V Air Heat Pump Model: AHUW126A0 + H12SNE (12 kW / 40000 btu)

A complete air heat pump system for domestic hot water and heating.

The LG range of Therma V air to water heat pumps offer a very cost effective way of providing heating to new build and retrofit applications with COP values up to 4.55. The systems come in a range of outputs from 9kw up to 16kw with the flexibility to provide various styles of outputs providing hot water for under floor, radiators and domestic hot water. LG are the world’s largest air heat pump and air conditioning manufacturer having the resources to provide products that are fully tested for reliability and durability with full technical back up provided.

Therma V uses free energy in air, and adopts the inverter technology. So, it is far more fuel-efficient compared to other heating devices and, thus, is very economical. When you use a gas or oil boiler, or an electric radiator, you can get exactly the same effect based on your input. However, Therma V, with the application of the same amount of energy, emits more than four energy items, which can be used. This is the strength of the Air to Water Heat pump to which LG inverter technology is applied.


Key Product Feature's:

  • Model: AHUW126A0 + H12SNE
  • Nominal Heating - 12 kW
  • COP Heating - 4.46
  • 240Volt 1 phase
  • Refrigerant R410A
  • Option of solar collector connection
  • Rated to -20DegC Heating
  • Dimensions Outdoor: L1760, W600, D650
  • Dimensions Indoor: L850, W390, D315
  • Heating for DHW and heating
  • Weight 204Kg ( indoor and outdoor)